The force of the impact can be adjusted from light to full by turning the metal ring while the handpiece is either off or running. The speed of the hammer action can be varied from 0-5,000 strokes per minute with the manual dial on the control box, or the optional foot speed control.

The 1011 Kit includes the MH-011 Hammer Handpiece, FM3545 Control and the accessories shown below. The FC-2000 foot control must be ordered separately.

1011-2 Micro Motor Kit - 220/240 Volt version of kit.

1011 Kit Accessories:

3 - Anvil Points with Threaded Shanks, 1 - Anvil Point Adapter for Non-threaded Shank Accessories (2.35mm), Open end Wrench (5mm), 2 - Pins used to tighten Anvil Points, 1 - Anvil Point Holder used for shaping the point.

Also includes AT-1 Handpiece Tray, Safety Glasses, and Spare Pair of Motor Brushes.

Accessories and Motor Brushes

Anvil Point with Threaded Shank 10177K $6.00
Anvil Point Adapter for Threaded Anvil Point H8-32 $34.00
Adapter for Non-Threaded Shank Accessories H8-35 $34.00
Open End Wrench (5mm) H8-38 $3.50
Pave Diamond Point R146 $22.00
Carbide Engraving Point EP165 $6.25
Motor Brushes for MH-011 (Pair) HP813514 $22.00

FM3545 Control $235.00

Provides variable speed with dial or foot pedal. Has front panel On/Off, Manual/Foot and Forward/Reverse switches and Power-On light. For use with MH-145 and MH-011 handpieces only. Built-in overload protection. 6' long power cord with 3-prong plug. With the MH-011 attached, the control must be used in the Forward position only.

FC-2000 Optional Foot Control $55.00

Solid state control in heavy duty plastic housing. Varies handpiece speed from off to full speed while control selection switch is in FOOT position only.